英文字典,中文字典,查询,解释,review.php


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       


安装中文字典英文字典辞典工具!

安装中文字典英文字典辞典工具!










  • Sudden Adhesion Problems - Bambu Lab Community Forum
    Been printing up a storm for the past month with PLA I found using the Hot Plate was best, and was rarely having any adhesion problems… until last night Suddenly, out of the blue, all of my prints started failing with bad first layer adhesion – and there had been no changes in either machine or filament reels since earlier in the day when everything was fine So I: Carefully cleaned the
  • Bambu 3D Effect Sheet - Bambu Lab X1C - Bambu Lab Community Forum
    Just added a Carbon fibre 3D effect plate and was having problem with the prints sticking but the advice hear solved the problem so thanks to the contributors I have a question though
  • The Bambu Lab High Temperature Smooth PEI Plate troubleshooting guides
    Over time, users might face issues with inadequate build plate adhesion Here are some recommended steps for troubleshooting adhesion problems with the Bambu Lab High-Temperature Plate
  • Having Problems with adhesion to the build plate. (Textured Bambulab . . .
    I am having trouble getting the prints to stay on the build plate This has only become a problem the last week or so I have tried many different “solutions” including the Bambulab wiki None have helped yet Any ideas out there?
  • Possible Printing Problems - Bambu Lab Wiki
    PLA model does not adhere well to the Cool Plate Problem When printing a model in PLA, the model loses adhesion and it rises from the printing surface Solution - Ensure that glue stick has been applied in a thin coat over the printing surface - Increase the No cooling for the first layer value from 1 to 3, in the Filament Settings → Cooling tab PETG model does not adhere well to the
  • Very frustrating issues with first layer adhesion when . . . - Reddit
    Are you finding the poor adhesion problem is along the entire perimeter of the build plate or mainly the front edge? I was experiencing poor bed adhesion at the front edge of the bed specifically and was able to improve first layer adhesion by increasing the ambient temperature of the room I store the P1P in to 26C and increasing the bed
  • Bambu Lab Textured PEI Plate Troubleshooting Guide
    This guide shows the process of cleaning the PEI textured plate and also gives some recommendations for better adhesion
  • P1P X1C - Adhesion Issues, possibly tips : r BambuLab - Reddit
    I found that for the cool plate heating to 50C solved most of my bed adhesion + warping issues 55 for Textured PEI


















中文字典-英文字典  2005-2009